merge

1 files changed, 4 insertions, 4 deletions

diff --git a/Software/Embedded_SW/Embedded/Modules/Thread/Thread_Winder.c b/Software/Embedded_SW/Embedded/Modules/Thread/Thread_Winder.c
index 1f7836ea5..70f32ce6d 100644
--- a/Software/Embedded_SW/Embedded/Modules/Thread/Thread_Winder.c
+++ b/Software/Embedded_SW/Embedded/Modules/Thread/Thread_Winder.c
@@ -322,7 +322,9 @@ uint32_t Winder_Presegment(void *SegmentDetails, uint32_t SegmentId)
         //     * calculate
         //     * 1. calculate speed according to JobTicket->processparameters->dyeingspeed
         //     * calculation input: traverse length in milimeters/pulses, number of rotations per traverse ==> length of traverse per rotation.
-        screw_horizontal_speed = InternalWinderCfg.segmentoffsetpulses /  InternalWinderCfg.NumberOfRotationPerPassage;
+        ScrewNumberOfSteps = InternalWinderCfg.segmentoffsetpulses;//*MotorsCfg[HARDWARE_MOTOR_TYPE__MOTO_SCREW].microstep;
+        ScrewNumberOfSteps -= 100;
+        screw_horizontal_speed = ScrewNumberOfSteps /  InternalWinderCfg.NumberOfRotationPerPassage;
         // calculation input#2: number of rotations per second - (basically: speed/winder perimeter. later - according to winder actual speed - calculate according to winder position accumulation in the last second.
         //RotationsPerSecond = dyeingspeed / (MotorsCfg[HARDWARE_MOTOR_TYPE__MOTO_WINDER].pulleyradius * PI);
         RotationsPerSecond =  OriginalMotorSpd_2PPS[WINDER_MOTOR] / MotorsCfg[HARDWARE_MOTOR_TYPE__MOTO_WINDER].pulseperround;
@@ -343,10 +345,8 @@ uint32_t Winder_Presegment(void *SegmentDetails, uint32_t SegmentId)
     //     * 3. calculate cart travel length from winding parameters
     //     * 4. start move of travel length
     //     * 5. register motor nBusy callback. this callback will flip between move(traverse length, hardstop) and goto(0), with handline og the coneshape and adjusting maxspeed
-        ScrewNumberOfSteps = InternalWinderCfg.segmentoffsetpulses;//*MotorsCfg[HARDWARE_MOTOR_TYPE__MOTO_SCREW].microstep;
-        ScrewNumberOfSteps -= 100;
         temp = SYS_CLK_FREQ;
-        temp *= InternalWinderCfg.segmentoffsetpulses;
+        temp *= ScrewNumberOfSteps;
         temp /= ScrewSpeed;
         ScrewRunningTime = temp;//(SYS_CLK_FREQ*InternalWinderCfg.segmentoffsetpulses)/ScrewSpeed;
         REPORT_MSG(ScrewNumberOfSteps,"Winder pre segment - ScrewNumberOfSteps");