/Software/Stubs Collection/stubs/Scripts/

• ../
• 11.cs
• 12345.cs
• Assemblies
• BTSR
• CalculateContinuous.cs
• ChangePidDuringRun.cs
• ConvertFloat2Bytes.cs
• Defines
• Dispenser_setup.cs
• Head_EEPROM.cs
• Head_Type_Indification.cs
• Head_Type_Indification_2.cs
• I2C_RW_Dispenser_EEPROM.cs
• I2C_RW_Main_Card_EEPROM_Save_Main_SN.cs
• Jig_Tester
• Main card Watchdog test.cs
• MidTank Calibration.pproj
• Moshe Copy Files.exe
• Motor_Get_Param_Horizontal_Printing.cs
• Motor_Get_Param_Horizontal_Printing1.cs
• Motor_Get_Param_Horizontal_Printing2.cs
• Motor_Get_Param_Horizontal_Printing3.cs
• Motor_Get_Param_Horizontal_Printing4.cs
• Motor_Get_Param_Horizontal_Printing_powerstep01.cs
• Motor_Get_Param_Horizontal_Printing_powerstep01_rev10.cs
• NewSpeedSensor.cs
• POPUP example for mati.cs
• Priming.pproj
• Priming1.pproj
• Read Dancer new.cs
• Read Dancer.cs
• Read Dispensers Serial Num.cs
• Read_Version.cs
• SS Head Sensor board.cs
• Set cleaning sequence.cs
• Set loading arm center.cs
• Tango_Main_PCB_ATP_sn_xxxxxxx.xlsx
• TestForVika.cs
• Twine_Tango_Main_Test12.docx
• Twine_Tango_Main_Test13.docx
• WHS_Test_EEPROM.cs
• WHS_waste_Tank_Calibration_Save_V0.pproj
• auto shutt off.cs
• blower_Q.cs
• change sublimation time.cs
• check_kval_load_arm.cs
• config head type to hed card eeprom.cs
• eepromati2.c
• eepromati3.c
• embeddedparametersbuild.cs
• embeddedparametersbuild_w_cleaning.cs
• load parameters from machine.cs
• magnet_new_head.cs
• motormov.cs
• new dispenser card GPIO.cs
• process parameters.cs
• progress_test.pproj
• read and store main card data.cs
• read embedded version.cs
• read write main eeprom fixed.cs
• read write main eeprom.cs
• read_cpu_eeprom.cs
• single temperature.cs
• temp.cs
• test halt.cs
• test.cs
• waste level.cs
• waste_level2.cs
• wd_enable.cs
• whs eeprom temporary 2.cs
• whs eeprom temporary.cs
• whs fans stop.cs